Laser-Cut Four-Hole Foam Insulation Pad for an Electric Boat
Laser-cut foam thermal insulation pad for an electric boat, with four round through-holes and an irregular opening with a rounded clearance notch. Finished by deburring.
Category:
Case Studies
key word:
Laser Cutting
- Product Description
-
Product Information
Manufacturing Process Laser cutting Material Foam Part Type Thermal insulation pad Application Electric boat Visible Features Four round through-holes in two pairs, an irregular opening with a rounded clearance notch, and narrow sections between the holes and opening Post-processing Deburring Four-Hole Diameter and Spacing
On small holes, the width of the laser cut and local heating can change the finished diameter or distort the opening. Center-to-center spacing matters because all four holes must align at the same time.
Cutout Corners and Narrow Sections
The internal corners and rounded clearance notch define the opening profile. The narrow sections between the holes and opening need enough material to remain intact during cutting and deburring. The condition of the cut edge depends on the foam composition, sheet thickness and laser settings.
Measuring the Pad in Its Relaxed State
Lay the pad flat without stretching it or pressing on the foam. Check the outer profile, hole diameters, hole spacing and cutout dimensions in this position to avoid measurement error from deformation.
Project Value
The four-hole pattern and clearance opening must fit the same assembly. Tight drawing requirements for hole position or minimum web width increase the difficulty of meeting both fit and edge requirements.
Key words:- laser cut foam insulation pad
- electric boat thermal insulation pad
- four hole foam pad with cutout
Related products
Message
If you are interested in our products, welcome to leave a message, we will contact you as soon as possible!